After a quick trip to Lowes for a few strips of 1" strap steel, and a bunch of hammering and drilling, the bracket for the Accusump is basically done; I just need to weld in a couple of reinforcement pieces so it doesn't vibrate all over the place. No pictures yet, but it's bolting to the firewall and the back of the passenger side shock tower, right where the battery used to be. (I'm actually reusing the lower two attachment points for the battery support for the lower part of the bracket; the upper part is attached to the firewall on one side, and the left upper control arm bolt on the other, with a welded piece in between the top and bottom for rigidity). I'll need to pick up a 1/2" NPT to -12AN 90-degree hose end for the plumbing on it, plus some -4AN line and a couple of fittings so I can relocate the pressure gauge somewhere useful, and I'll probably want to rubber-mount it to the bracket. It looks like it'll clear the hood without any trouble at all, and there's tons of room all around for everything else. Progress!